In a restaurant setting, the back splash behind the kitchen sinks is most often made from sheet metal. This is because sheet metal is quite strong, versatile, and easy to install. Before Sheet Metal Installation in Massachusetts RI can begin, however, there needs to be some prep work which is finished beforehand. Here is a breakdown of what needs to e done before the sheet metal can be installed.
Power Down
Before the metal can be installed, all of the power should be turned off. To verify this, after the breakers are switched off, use a voltage tester near the outlets. Simply hold the tester against the outlet or the light switch and a light will display on the device if a live voltage is still present.
Remove Covers
Use a screwdriver to remove the plates or covers to any light switches and/or outlets that will be in the area the back splash will cover. The flat head of the screwdriver may be needed to pry the cover off as they can become stuck on over the course of time.
Clean
It is almost certain the wall behind the sink will be dirty and grimy. Take a strong detergent and spray it along the entire wall to remove any built-up gunk that has accumulated over the years. Make sure to wipe all of the detergents away after cleaning, however, as any remnants of it can actually prevent the adhesives from sticking.
Inspect
The entire wall behind the back splash should be inspected before attempting Sheet Metal Installation in Massachusetts. Any loose tiles or crumbling tiles should be fixed as these will certainly interfere with the adhesive used to install the sheet metal. The wall should also be completely flat before installation. If it is not a carpenter may need to be called in to correct the problem.
Browse our website for sheet metal solutions. A member of the staff can answer any questions which may be posed and if the project needs a professional touch, an estimate can be quickly given after a visit to the job site. Why try and do it by oneself when a professional can have the job done quicker and easier?
